2020 Infiniti QX80 LimitedFACTORY OEM SERVICE PROCEDURE

DTC Detection Logic

NOTE:
  • If DTC P26A5 is displayed with DTC P0117 or P0118, first perform the trouble diagnosis for DTC P0117 or P0118. Refer to DTC Index .
  • If DTC P26A5 is displayed with DTC P26A3 first perform the trouble diagnosis for DTC P26A3. Refer to DTC DescriptionΒ .
  • If DTC P26A5 is displayed with DTC P26A6, or P26A7 first perform the trouble diagnosis for DTC P26A6, or P26A7. Refer to DTC DescriptionΒ .

DTC No.

Trouble diagnosis name

(Trouble diagnosis content)

DTC detecting condition

Possible Cause

P26A5

ENGINE COOLANT B/V A POSI SEN

(Engine coolant bypass valve A position sensor circuit range/performance)

ECM detects the following status:

  • A voltage signal transmitted from the multi-way control valve position sensor is 4.76 V or more/4.3 V or less. Outside the above threshold when the valve is moved to the upper side stopper after ignition OFF.
  • A voltage signal transmitted from the multi-way control valve position sensor is 0.8 V or more/0.34 or less. Outside the threshold when the valve is moved to the lower side stopper after engine start.
  • Harness or connectors

    (Multi-way control valve position sensor circuit is open or shorted.)

  • Multi-way control valve position sensor
  • Sensor power supply 2
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.