2020 Infiniti QX80 LimitedFACTORY OEM SERVICE PROCEDURE

Confirmation Procedure

  1. PRECONDITIONING 
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE-I 
    1. Clear the mixture ratio self-learning value. Refer to Work Procedure .
    2. Start engine.

    Is it difficult to start engine?

    YES

    GO TO 3.

    NO

    GO TO 4.

  3. RESTART ENGINE 

    If it is difficult to start engine, the fuel injection system has a malfunction, too.

    Crank engine while depressing accelerator pedal.

    NOTE: When depressing accelerator pedal three fourths (3/4) or more, the control system does not start the engine. Do not depress accelerator pedal too much.

    Does engine start?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    Check exhaust and intake air leakage visually.

  4. PERFORM DTC CONFIRMATION PROCEDURE-II 
    1. Keep engine idle for at least 5 minutes.
    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    GO TO 5.

  5. PERFORM DTC CONFIRMATION PROCEDURE-III 
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Start engine.
    5. Maintain the following conditions for at least 10 consecutive minutes.

      Hold the accelerator pedal as steady as possible.

      Vehicle speed

      50 - 120 km/h (31 - 75 MPH)
      CAUTION: Always drive vehicle at a safe speed.
    6. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    INSPECTION END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.