2019 Infiniti QX30 Essential, AWDFACTORY OEM SERVICE PROCEDURE

Work Procedure

  1. PRECONDITION-1 

    SYMBOL With CONSULT

    1. Turn ignition switch ON.
    2. On the CONSULT screen, select "ENGINE" >> "WORK SUPPORT" >> "TEACH IN OF THROTTLE VALVE STOP".
    3. Touch "Start".

    GO TO 2.

  2. PRECONDITION-2 

    SYMBOL With CONSULT

    Check the following conditions.

    ENGINE SPEED

    10 1/min

    COOLANT TEMPERATURE

    5 deg.C (41 deg.F) temperature 100 deg.C (212 deg.F)

    C/AIR TENP/S U/STRM THRTL

    40 deg.C (104 deg.F)

    ACCEL PEDAL SENSOR

    5%

    Is the condition satisfied?

    YES

    GO TO 3.

    NO

    Satisfy the condition, and GO TO 3.

  3. START 

    SYMBOL With CONSULT

    Touch "Start" and wait a few seconds.

    Is "Test Finished" displayed on CONSULT screen?

    YES

    END

    NO

    Follow the instruction of CONSULT display.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.