Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Description
Description
The crankcase ventilation system allows the discharging of excess pressure and excessive gas sent from the crankcase, feeding them back to the engine through the induction system, and combusting them under any engine operating condition.
- Pressure sensor downstream of throttle valve (Engine load)
- Accelerator pedal position sensor (Accelerator pedal position)
- BCM (Ambient temperature)
|
|
Full-load operation vent line heater element |
|
Fuel tank ventilation connector |
|
Vent valve |
|
|
Oil separator |
|
Partial load operation crankcase ventilation valve |
||
|
A |
Partial load bleed line |
B |
Vent line for oil separator |
C |
Purge line |
|
D |
Wide open throttle bleed line |
E |
Engine ventilation line |
Crankcase Ventilation Description of Function
The crankcase ventilation has functions as follows:
- Normal mode crankcase ventilation function
- Full-load mode crankcase ventilation function
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
