Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Function Check
- CHECK ICC BRAKE SWITCH FUNCTION
WITH CONSULT
- Turn ignition switch ON.
- Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT.
- Check "BRAKE SW1" indication under the following conditions.
Monitor item
Condition
Indication
BRAKE SW1
(ICC brake switch)
Brake pedal
Slightly depressed
OFF
Fully released
ON
WITHOUT CONSULT
- Turn ignition switch ON.
- Check the voltage between ECM harness connector terminals as per the following.
ECM
Condition
Voltage
Connector
+
-
Terminal
Terminal
E20
140
(ICC brake switch signal)
152
Brake pedal
Slightly depressed
Approx. 0 V
Fully released
Battery voltage
Is the inspection result normal?
YES
INSPECTION END
NO
Go to Diagnosis Procedure .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.