Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Function Check
- CHECK FUEL TANK TEMPERATURE (FTT) SENSORÂ
- Turn ignition switch OFF.
- Disconnect fuel level sensor unit and fuel pump harness connector.
- Remove fuel level sensor unit. Refer to Removal and Installation .
- Check resistance between fuel level sensor unit and fuel pump terminals by heating with hot water as shown in the figure, below.
Terminals
Condition
Resistance (k Ohms)
4 and 5
Temperature [ deg. C (deg. F)]
20 (68)
2.3-2.7
50 (122)
0.79-0.90
Is the inspection result normal?
YES
GO TO 2.
NO
Proceed to Diagnosis Procedure .
- CHECK INTERMITTENT INCIDENTÂ
Check intermittent incident. Refer to Inspection .
Is the inspection result normal?
YES
INSPECTION END
NO
Proceed to Diagnosis Procedure .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.