2018 Infiniti QX80 AWDFACTORY OEM SERVICE PROCEDURE

Component Function Check

  1. CHECK COOLING FAN FUNCTION 

    SYMBOL WITH CONSULT

    1. Start the engine.
    2. Perform "FAN DUTY CONTROL" in "ACTIVE TEST" mode with CONSULT.
    3. Check that cooling fan speed varies according to the percentage.
      NOTE: Speed changes gradually as the percentage changes.

    SYMBOL WITHOUT CONSULT

    1. Start the engine and warm up the engine until engine coolant temperature reaches at least 98 deg. C (209 deg. F).
    2. Check that cooling fan speed increase.

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Proceed to Diagnosis Procedure .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.