2018 Infiniti QX30 BaseFACTORY OEM SERVICE PROCEDURE

Work Procedure

WARNING: This page is about a different car, the 2018 Infiniti Q60. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Use "Manual Configuration" only when "Parts number" of ADAS control unit cannot be read.
  • If an error occurs during configuration, start over from the beginning.
  1. CHECKING PARTS NUMBER 

    SYMBOL WITH CONSULT

    1. Select "Before Replace ECU" of "Read/Write Configuration".
    2. Check that "Parts number" is displayed on CONSULT.

    Is "Parts number" displayed?

    YES

    GO TO 2.

    NO

    GO TO 6.

  2. VERIFYING PARTS NUMBER (1) 

    SYMBOL WITH CONSULT

    Compare a "Parts number" displayed on the CONSULT screen with the one searched by using FAST (service parts catalogue) to check that these "Parts number" agree with each other.

    NOTE: For the "Parts number" searched by using FAST (service parts catalog), use the last five digits of the "Parts number".

    GO TO 3.

  3. SAVING PARTS NUMBER 

    SYMBOL WITH CONSULT

    Save "Parts number" on CONSULT.

    GO TO 4.

  4. REPLACE ADAS CONTROL UNIT (1) 

    Replace ADAS control unit. Refer to Removal and Installation .

    GO TO 5.

  5. WRITING (AUTOMATIC WRITING) 

    SYMBOL WITH CONSULT

    1. Select "After Replace ECU" of "Re/programming, Configuration" or that of "Read / Write Configuration".
    2. Select the "Parts number" agreeing with the one stored on CONSULT and the one searched by using FAST (service parts catalogue) to write the "Parts number" into the ADAS control unit.

    GO TO 8.

  6. REPLACE ADAS CONTROL UNIT (2) 

    Replace ADAS control unit. Refer to Removal and Installation .

    GO TO 7.

  7. WRITING (MANUAL WRITING) 

    SYMBOL WITH CONSULT

    1. Select "Manual Configuration".
    2. Select the "Parts number" searched by using FAST (service parts catalogue) to write the "Parts number" into the ADAS control unit.
      NOTE: For the "Parts number" searched by using FAST (service parts catalog), use the last five digits of the "Parts number".

    GO TO 8.

  8. VERIFYING PARTS NUMBER (2) 

    SYMBOL WITH CONSULT

    Compare a "Parts number" displayed on the CONSULT screen with the one searched by using FAST (service parts catalogue) to check that these "Parts number" agree with each other.

    NOTE: For the "Parts number" searched by using FAST (service parts catalog), use the last five digits of the "Parts number".

    GO TO 9.

  9. OPERATION CHECK 

    Confirm that each function controlled by ADAS control unit operates normally.

    WORK END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.