Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Data Monitor Mode
Monitored Item
For reference values of the following items, refer to Reference Value .
|
Monitored item |
Unit |
Description |
Remarks |
|
ALT DUTY |
% |
The item is displayed but is not used. |
|
|
BAT TEMP SEN |
V |
The signal voltage from the main battery temperature sensor is displayed. |
|
|
ENG RESTART B/R STK CNT |
-- |
Indicates a count for engine restart bypass relay function diagnosis. |
|
|
BAT CUR SEN |
mV |
The signal voltage of main battery current sensor is displayed. |
|
|
CML B/DCHG CRNT |
-- |
Cumulative main battery discharge current is displayed. |
|
|
LOAD SIGNAL |
On/Off |
|
|
|
HEATER FAN SW |
On/Off |
Indicates [ON/OFF] condition from the heater fan switch signal. |
|
|
BRAKE SW2 |
On/Off |
Indicates [ON/OFF] condition of stop lamp switch signal. |
|
|
BATTERY STS |
OK/NG |
Indicated [OK/NG] condition of main battery output. |
EMCM judges whether stop/start system is possible according to main battery state. |
|
AT STOP START SW |
On/Off |
Displays the activation status of stop/start system. |
|
|
ALT DUTY SIG |
On/Off |
|
|
|
BATTERY VOLT |
V |
Indicates power supply voltage for EMCM. |
|
|
SUB-BATTERY TEMP SENSOR |
V |
Indicates a signal voltage of sub battery temperature sensor. |
|
|
SUB-BATTERY VOLTAGE |
V |
Indicates sub battery power supply voltage. |
|
|
CMLTV S/BAT DISCHG CRNT |
-- |
Indicates sub-battery discharge current cumulative value. |
|
|
SUB-BAT CURRENT SEN V |
mV |
Indicates a signal voltage of the sub battery current sensor. |
|
|
C/DYNAMOMETER MODE |
On/Off |
Indicates the chassis dynamometer mode status. |
|
|
BRAKE PEDAL POSITION SW |
On/Off |
Indicates [ON/OFF] condition from the brake pedal position switch signal. |
|
|
SUB-BATTERY STATUS |
OK/NG |
Indicates [OK/NG] condition of sub battery output. |
EMCM judges whether stop/start system is possible according to battery state. |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
