Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Infiniti QX30 BaseFACTORY OEM SERVICE PROCEDURE
Work Procedure
WARNING: This page is about a different car, the 2018 Infiniti Q60. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITION-1
With CONSULT
- Turn ignition switch ON.
- On the CONSULT screen, select "ENGINE">>"DATA MONITOR">>"SEN ROTOR ADAPT CMPLT".
- Start the engine.
- Push stop/start OFF switch to deactivate stop/start system.
- Shift selector lever to manual mode (1st gear).
GO TO 2.
- START
- Accelerate to 20 km/h (13 MPH), and then release the accelerator pedal to decelerate for 4 seconds or more (in the fuel cut status).CAUTION: Never rev up the engine speed to 4, 000 rpm or more.
- Check "SEN ROTOR ADAPT CMPLT" display.
Is "YES" displayed on CONSULT screen?
YES
END
NO
GO TO 1.
- Accelerate to 20 km/h (13 MPH), and then release the accelerator pedal to decelerate for 4 seconds or more (in the fuel cut status).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.