2018 Infiniti QX30 BaseFACTORY OEM SERVICE PROCEDURE

Idle Speeds Control

WARNING: This page is about a different car, the 2018 Infiniti Q60. However, it is still accessible from the selected car via links, so may be relevant.

Idling is maintained steady by controlling idle speed according to the operating condition of the engine and engine load when the accelerator pedal is not depressed.

ECM controls idle speeds according to the following sensors and signals.

  • Engine coolant temperature sensor
  • Pressure sensor downstream of throttle valve (Engine load)
  • Battery voltage
  • A/C auto amp. (air conditioner activation status)

ECM adjusts idle speed through the throttle valve control and determines fuel injection time according to the amount of intake air. In addition, ECM can adjust the ignition timing up to 20 degrees in retard or advance direction to stabilize idle speed.

NOTE: The ignition timing control responds faster than the throttle valve control. ECM controls idle speed according to the following operating conditions and engine load.
  • During warm-up
  • Shifting to D or R range
  • Turning on air conditioner compressor
  • Purge

During Warm-up 

During warm-up, ECM controls idle speed according to coolant temperature to quickly increase the catalyst temperature to the operating temperature after engine start.

Prerequisites for warm-up stage

  • Engine coolant temperature is 40 deg.C (104 deg.F) or less
  • N or P range

ECM increases idle speed to approximately 1, 100 - 1, 300 rpm for approximately 20 seconds after engine start. After this, if coolant temperature is less than 70 deg.C (158 deg.F), ECM increases idle speed 50 - 100 rpm more than the standard idle speed additionally for approximately 50 seconds.

Shifting to D or R Range 

ECM receives a shift position signal from TCM via drivetrain CAN communication, and when the shift position is in D or R range, ECM decreases idle speed to reduce creeping of the vehicle.

Turning on Air Conditioner Compressor 

To prevent engine speed from decreasing due to the activation of air conditioner compressor during idling, the A/C auto amplifier transmits an A/C status signal to ECM before turning ON the air conditioner compressor. ECM controls idle speed according to the signal.

Purge 

The idle speed control reduces speed fluctuation resulting from purge.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.