Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Work Procedure
- PRECONDITION-1
With CONSULT
- Turn ignition switch ON.
- On the CONSULT screen, select "ENGINE">>"WORK SUPPORT">>"RESETTING OF ADAPTION VALUES".
- Touch "Start".
GO TO 2.
- PRECONDITION-2
Check the following conditions.
ENGINE SPEED
≤ 10 1/min
COOLANT TEMPERATURE
5 deg.C (41 deg.F) ≤ temperature ≥ 100 deg.C (212 deg.F)
ACCEL PEDAL SENSOR
≤ 5%
Is the condition satisfied?
YES
GO TO 3.
NO
Satisfy the condition, and GO TO 3.
- START
Touch "Start" and wait a few seconds.
Is "COMPLETED" displayed on CONSULT screen?
YES
END
NO
Follow the instruction of CONSULT display.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.