Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Infiniti QX30 BaseFACTORY OEM SERVICE PROCEDURE
Removal and Installation: Installation
Note the following, and install in the reverse order of removal.
CAUTION:
- Never apply excessive impact to electronic stability program control unit, such as by dropping it.
- Never reuse electronic stability program control unit mounting bolt.
- Install electronic stability program control unit harness connector
, follow the procedure described below.
CAUTION:- The following procedure for installing the electronic stability program control unit harness connector must be followed. Otherwise, damage may be caused to the locking mechanism.
- Never touch, deform or damage electronic stability program control unit harness connector and of socket on electronic stability program control unit.
- Never allow any foreign objects, dirt or fluids to enter the socket or electronic stability program control unit harness connector. Otherwise, the electronic stability program control unit will be damaged and malfunction.
- Push the pawl
.
- Move the lever
in the direction
by approx. 90 degrees.
CAUTION: Never use tool. - After installing the electronic stability program control unit harness connector
, move the lever
in the direction
to secure the locking.
CAUTION: Never handle the connector by lever. The lever can otherwise be damaged.
- Perform adjustment after installation. Refer to AdjustmentΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
