2018 Infiniti QX30 BaseFACTORY OEM SERVICE PROCEDURE

Work Procedure

CAUTION: When the following operations are performed, always use CONSULT. (It cannot be performed by any means other than CONSULT.)
  1. CHECK THE VEHICLE STATUS 

    The vehicle must be on a level surface.

    Do want to start calibration?

    YES

    GO TO 2.

    NO

    WORK END

  2. PERFORM CALIBRATION 

    SYMBOL With CONSULT

    1. Select "ABS", "WORK SUPPORT", "Calibration of acceleration sensor" in this order.
    2. Touch "START".

    WORK END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.