Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Infiniti QX80 Base, AWDFACTORY OEM SERVICE PROCEDURE
Exploded View : Disassembly
Type: A002TX1491
| 1. | Rear bearing | 2. | Rotor assembly | 3. | Retainer |
| 4. | Front bearing | 5. | Front bracket assembly | 6. | Pulley |
| 7. | Pulley nut | 8. | Stator assembly | 9. | IC voltage regulator assembly |
| 10. | Diode assembly | 11. | Rear bracket assembly | 12. | Terminal set |
| : Always replace after every disassembly. | |||||
| : N•m (kg-m, ft-lb) | |||||
| : N•m (kg-m, in-lb) | |||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
