Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Infiniti QX30 BaseFACTORY OEM SERVICE PROCEDURE
Low Fuel Pressure Check
- INSPECTION START
With CONSULT
- Turn ignition switch OFF.
- Start the engine and let it idle.
- On CONSULT screen, select "FPCM" >> "DATA MONITOR" >> "FUEL PRESSURE".
- Check that the indicated value is between 400 kPa (4 bar, 4.08 kg/cm2 , 58 psi) and 670 kPa (6.7 bar, 6.834 kg/cm2 , 97.15 psi).
INSPECTION END
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.