2017 Infiniti QX30 BaseFACTORY OEM SERVICE PROCEDURE

DTC Confirmation Procedure

  1. PERFORM DTC CONFIRMATION PROCEDURE

    G-20 With CONSULT

    1. Start the engine and let it idle at least 10 seconds.
    2. Check self-diagnostic result of "FPCM".

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Proceed to DIAGNOSIS PROCEDURE .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.