Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Synchronization Of The Injection And Ignition Order
| 1 | Top dead center of cylinder 1 | 2 | Top dead center of cylinder 2 | 3 | Top dead center of cylinder 3 |
| 4 | Top dead center of cylinder 4 | ||||
| A | Crank angle | B | Multi-pulse wheel | C | Crankshaft position sensor signal |
| D | Cylinder 1 discriminate signal | E | Intake camshaft position sensor signal | F | Exhaust camshaft position sensor signal |
| G | Engine speed signal | ||||
| a | Intake camshaft adjustment range | b | Intake camshaft position sensor (low signal) | c | Exhaust camshaft adjustment range |
| d | Exhaust camshaft position sensor (low signal) | e | Polarities at intervals of crank angle 18° |
SYNCHRONIZATION OF THE INJECTION AND IGNITION ORDER
ECM reads voltage signals of intake camshaft position sensor, exhaust camshaft position sensor, and crankshaft position sensor to synchronize the order of fuel injections with that of ignitions when starting the engine. ECM detects the top dead center of Cylinder 1 according to a signal of crankshaft position sensor.
ENGINE SPEED SIGNAL CONTROL
Multi-pulse wheels with different polarities are installed to the crankshaft at intervals of crank angle 6°. Since the crankshaft position sensor is installed opposed to the multi-pulse wheel, pulse signals of 5 V and 0 V are generated during the rotation of crankshaft. In addition, the multi-pulse wheels have polarities at intervals of crank angle 18° to completely match the crank position.
ECM transmits a short-resistant engine speed signal via CAN communication based on a signal of crankshaft position sensor.
- Detection of rotation direction: When the engine stops or temporarily rotates in the opposite direction immediately before stopping, a pulse signal of the crankshaft position sensor changes. Since ECM detects the change in rotation direction through the above mechanism, crankshaft angle position can be accurately detected any time. This information is required, in particular, when quickly starting the engine in the stop/start system.
- When ECM cannot receive a crankshaft position sensor signal, ECM uses an intake camshaft position sensor signal or exhaust camshaft position sensor signal to enable the vehicle to be driven. When ECM cannot receive an intake camshaft position sensor signal, ECM uses an exhaust camshaft position sensor signal to detect the position of the top dead center of Cylinder 1. When both camshaft position sensor signals cannot be received, ECM performs ignition and injection to execute an emergency start after detecting crank angle 360°.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
