Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Starting Mixture Enrichment Control
SYSTEM DIAGRAM
SYSTEM DIAGRAM
During cold start, ECM enables the injection of more fuel than normal start to perform a smooth engine start.
ECM calculates the injection time of the starting mixture enrichment control, based on the following sensors and signals.
- Engine coolant temperature sensor
- Crankshaft position sensor (Engine speeds, Crankshaft position)
- Battery (Battery voltage)
The starting mixture enrichment control continues operating until coolant temperature and engine speed exceed the specified value. Fuel injection time calculated by ECM decreases as the coolant temperature rises. In addition, fuel injection time changes, depending on battery voltage. ECM extends fuel injection time to achieve sufficient fuel injection when the battery voltage is low.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
