2017 Infiniti QX30 BaseFACTORY OEM SERVICE PROCEDURE

Work Procedure

  1. REPLACE ELECTRONIC STABILITY PROGRAM CONTROL UNIT

    Replace the electronic stability program control unit. Refer to REMOVAL AND INSTALLATION .

    GO TO STEP 2  .

  2. WRITING VEHICLE SPECIFICATION

    Perform the configuration. Refer to DESCRIPTION .

    GO TO STEP 3  .

  3. CALIBRATION OF ACCELERATION SENSOR

    Perform the calibration of acceleration sensor. Refer to DESCRIPTION .

    GO TO STEP 4  .

  4. PERFORM VIN REGISTRATION

    Perform the VIN REGISTRATION. Refer to DESCRIPTION .

    GO TO STEP 5  .

  5. CHECK ALL ECU SELF-DIAGNOSIS RESULTS

    1. Erase all ECU self-diagnosis results using CONSULT.
    2. Turn the ignition switch OFF.
    3. Turn the ignition switch ON and wait for 2 seconds or more.
    4. Check that all ECU self-diagnosis results have no DTC.

    WORK END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.