2017 Infiniti QX30 BaseFACTORY OEM SERVICE PROCEDURE

Work Procedure

  1. STEP 1

    • Move seat slide position and seat reclining position to the foremost positions.
    • Move seat lift position (front and rear) to the lowest position.

    GO TO STEP 2Β  .

  2. STEP 2

    Select "Normalization" in "ACTIVE TEST" mode of "AUTO DRIVE POS." or "Passenger seat control unit" using CONSULT.

    END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.