2017 Infiniti QX30 BaseFACTORY OEM SERVICE PROCEDURE

Data Monitor

NOTE:

The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor Item Contents
STRG SW CRRNT -
Current Limitation -
STEERING SENSOR -
STEERING ANGLE -
STEERING ANGLE SENSOR STATUS -
HIGH BEAM STATUS Display the status of combination switch (High beam)
FRONT WIPER Display the status of combination switch (Front wiper)
FR WASHER SW Display the status of combination switch (Front washer)
RR WIPER Display the status of combination switch (Rear wiper)
IND SIG -
HEATED STEERING WHEEL -
CRUISE CONTROL FUNCTION Display the status of cruise control lever
UP SW Display the status of steering switch
DOWN SW Display the status of steering switch
VOLUME "+" BUTTON Display the status of steering switch
VOLUME "-" BUTTON Display the status of steering switch
REPEAT KEY -
MUTE BUTTON -
GEAR POSITION Display the status of paddle shifter
SUPPLY VOLTAGE -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.