Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Infiniti Q60 Base, AWDFACTORY OEM SERVICE PROCEDURE
Around View Monitor System
AROUND VIEW MONITOR SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B2720 | CORNER SENSOR [RL] |
| DTC B2721 | CENTER SENSOR [RL] |
| DTC B2722 | CENTER SENSOR [RR] |
| DTC B2723 | CORNER SENSOR [RR] |
| DTC B2724 | SONAR CONTROL UNIT |
| DTC B2729 | CORNER SENSOR [FL] |
| DTC B272A | CENTER SENSOR [FL] |
| DTC B272B | CENTER SENSOR [FR] |
| DTC B272C | CORNER SENSOR [FR] |
| DTC B272D | FRONT BUZZER |
| DTC U0428 | STEERING ANGLE SENSOR |
| DTC U1000 | CAN COMM CIRCUIT |
| DTC U1010 | CONTROL UNIT (CAN) |
| DTC U111A | REAR CAMERA IMAGE SIGNAL CIRCUIT |
| DTC U111B | SIDE CAMERA RH IMAGE SIGNAL CIRCUIT |
| DTC U111C | FRONT CAMERA IMAGE SIGNAL CIRCUIT |
| DTC U111D | SIDE CAMERA LH IMAGE SIGNAL CIRCUIT |
| DTC U1232 | STEERING ANGLE SENSOR |
| DTC U1302 | CAMERA POWER VOLT |
| DTC U1303 | LED POWER SUPPLY VOLT |
| DTC U1304 | CAMERA IMAGE CALIBRATION |
| DTC U1305 | CONFIG UNFINISH |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.