2017 Infiniti Q60 Base, AWDFACTORY OEM SERVICE PROCEDURE

Work Procedure: FPCM

  1. PERFORM CONFIGURATION

    G-20 With CONSULT

    1. Turn Ignition Switch ON.
    2. Select the "Re/programming, Configuration" of CONSULT.
    3. Perform configuration according to the CONSULT display.

    GO TO STEP 2  .

  2. WRITING MODE SELECTION

    G-20 CONSULT Configuration

    Select "CONFIGURATION" of FSCM.

    When writing saved data 

    GO TO STEP 3  .

  3. PERFORM "Before ECU Replacement"

    G-20 CONSULT Configuration

    Select "Before ECU Replacement". (If necessary)

    GO TO STEP 4  .

  4. PERFORM "Before ECU Replacement"

    G-20 CONSULT Configuration

    Perform "Before ECU Replacement" according to the CONSULT display. (If necessary)

    GO TO STEP 5  .

  5. PERFORM CONFIGURATION

    G-20 With CONSULT

    1. Turn Ignition Switch ON.
    2. Select the "Re/programming, Configuration" of CONSULT.
    3. Select the "After ECU Replacement".
    4. Select the "Manual Configuration". (If necessary)
    5. Confirm and/or change setting value for each item.
    6. Perform configuration according to the CONSULT display.

    GO TO STEP 6  .

  6. CHECK DTC

    G-20 With CONSULT

    1. Turn Ignition Switch OFF and wait for 10 seconds or more.
    2. Turn Ignition Switch ON.
    3. Perform self-diagnosis.
    4. Check that no DTC is detected.

    WORK END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.