Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Test
- PRECONDITION-1
With CONSULT
- Turn Ignition Switch ON.
- On the CONSULT screen, select "ENGINE">>"WORK SUPPORT">>"TEACH IN OF THROTTLE VALVE STOP".
- Touch "Start".
GO TO STEP 2 .
- PRECONDITION-2
Check the following conditions.
ENGINE SPEED ≤ 10 1/min COOLANT TEMPERATURE 5°C (41°F) ≤ temperature ≥ 100°C (212°F) C/AIR TENP/S U/STRM THRTL ≤ 40°C (104°F) ACCEL PEDAL SENSOR ≤ 5% Is the condition satisfied?
YES
GO TO STEP 3 .
NO
Satisfy the condition, and GO TO STEP 3 .
- START
Touch "Start" and wait a few seconds.
Is "Test Finished" displayed on CONSULT screen?
YES
END
NO
Follow the instruction of CONSULT display.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.