Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Chassis Dynamometer Mode: Description
This function must be used when performing the 2-wheel drive test (e.g. with 2-wheel chassis dynamometer, speedometer tester). (For details, refer to WORK PROCEDURE .)
The use of this mode is essential to avoid torque control and to perform a proper test with the 2-wheel chassis dynamometer. Charge warning lamp indicates this mode is set by blinking.
- Chassis Dynamometer Mode must be set when performing test with 2-wheel chassis dynamometer.
- At the end of test, always cancel Chassis Dynamometer Mode and check that the charge warning lamp turns OFF.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.