2016 Infiniti Q50 Base, AWDFACTORY OEM SERVICE PROCEDURE

Battery Current Sensor

WARNING: This page is about a different variant/trim than selected.

The power generation voltage variable control enables fuel consumption to be decreased by reducing the engine load which is caused by the power generation of the generator.

Based on sensor signals, ECM judges whether or not the power generation voltage variable control is performed. When performing the power generation voltage variable control, ECM calculates the target power generation voltage based on the sensor signal. And ECM sends the calculated value as the power generation command value to IPDM E/R.

CAUTION:

Never connect the electrical component or the ground wire directly to the 12V battery terminal. The connection causes the malfunction of the power generation voltage variable control, and then the 12V battery discharge may occur.

The battery current sensor is installed to the 12V battery negative cable. The sensor measures the charging/discharging current of the 12V battery.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.