WARNING: This page is about a different variant/trim than selected.

BCM performs fail-safe control when any DTC are detected.

Display contents of CONSULT	Fail - safe	Cancellation
B2192: ID DISCORD BCM-ECM *	Inhibit setting the vehicle to READY	Erase DTC
B2193: CHAIN OF BCM-ECM *	Inhibit setting the vehicle to READY	Erase DTC
B2195: ANTI-SCANNING	Inhibit setting the vehicle to READY	Ignition switch ON → OFF
B2198: NATS ANTENNA AMP	Inhibit setting the vehicle to READY	Erase DTC
B261E: VEHICLE TYPE	Inhibit setting the vehicle to READY	When HPCM status signal (CAN) is received normally from HPCM
B26F1: IGN RELAY OFF	Inhibit setting the vehicle to READY	When the following conditions are fulfilled Ignition switch ON signal (CAN: Transmitted from BCM): ON Ignition switch ON signal (CAN: Transmitted from IPDM E/R): ON
B26F2: IGN RELAY ON	Inhibit setting the vehicle to READY	When the following conditions are fulfilled Ignition switch ON signal (CAN: Transmitted from BCM): OFF Ignition switch ON signal (CAN: Transmitted from IPDM E/R): OFF
B26F7: BCM	Inhibit setting the vehicle to READY by Intelligent Key system	When room antenna and trunk room antenna functions normally

NOTE:

* : "ECM" is indicated on CONSULT display, however this means HPCM.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Fail-Safe Control By DTC