Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Infiniti QX70 AWDFACTORY OEM SERVICE PROCEDURE
Component Parts Location
| 1. | BCM M118, M119, M121, M122, M123 | 2. | IPDM E/R E5, E6, F7 | 3. | Push Button Ignition Switch M50 |
| 4. | Unified Meter And A/C Amp. M66, M67 | 5. | Key Warning Lamp (Combination Meter M53) | 6. | Stop Lamp Switch E110 |
| 7. | A/T Assembly Connector F51 | 8. | TCM (Built In A/T Assembly) F151 | ||
| A. | Dash Side Lower (Passenger Side) | B. | Engine Room Dash Panel (RH) | C. | View With The Cluster Lid C Removed |
| D. | Located On The Combination Meter | E. | Behind The Instrument Assist Lower Panel | F. | A/T Assembly |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.