Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Infiniti QX70 AWDFACTORY OEM SERVICE PROCEDURE
Component Function Check
- CHECK FUNCTION
- Select "PUSH SW" in "Data Monitor" mode with CONSULT.
- Check the push-button ignition switch signal under the following condition.
Test item Condition Status PUSH SW Push-button ignition switch is pressed ON Push-button ignition switch is not pressed OFF Is the indication normal?
YES
INSPECTION END
NO
Go to DIAGNOSIS PROCEDURE .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.