Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Infiniti Q60 Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Cruise Control System DTCS
CRUISE CONTROL SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) INDEX
| DTC | Description |
|---|---|
| C1A00 | CONTROL UNIT |
| C1A01 | POWER SUPPLY CIRCUIT 1, C1A02 POWER SUPPLY CIRCUIT 2 |
| C1A03 | VEHICLE SPEED SENSOR |
| C1A04 | ABS/TCS/VDC SYSTEM |
| C1A05 | BRAKE SW/STOP LAMP SW |
| C1A06 | OPERATION SW |
| C1A12 | LASER BEAM OFF CENTER |
| C1A13 | STOP LAMP RELAY |
| C1A14 | ECM |
| C1A15 | GEAR POSITION |
| C1A16 | RADAR STAIN |
| C1A18 | LASER AIMING INCMP |
| C1A21 | UNIT HIGH TEMP |
| C1A24 | NP RANGE |
| C1A26 | ECD MODE MALFUNCTION |
| C1A27 | ECD POWER SUPPLY CIRCUIT |
| C1A33 | CAN TRANSMISSION ERROR |
| C1A34 | COMMAND ERROR |
| U0121 | VDC CAN 2 |
| U0401 | ECM CAN 1 |
| U0402 | TCM CAN 1 |
| U0415 | VDC CAN 1 |
| U1000 | CAN COMM CIRCUIT |
| U1010 | CONTROL UNIT (CAN) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
