Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSINFINITI2015Q60 BASE, 2D CONVERTIBLEREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY CONTROL SYSTEM (CONVERTIBLE)SYSTEM DESCRIPTIONINTELLIGENT KEY SYSTEM/ENGINE START FUNCTIONCOMPONENT PARTS LOCATION

2015 Infiniti Q60 Base, 2D Convertible

Component Parts Location

2015 Infiniti Q60 Base, 2D ConvertibleSECTION Component Parts Location

Fig 1: Security Control System Component Parts Location (1 Of 2)

Courtesy of NISSAN NORTH AMERICA, INC.

1.	Inside key antenna (console) M146	2.	Remote keyless entry receiver M104	3.	IPDM E/R E5, E6, E7, E9,
4.	BCM M118, M119, M121, M122, M123	5.	Horn (low) E67, E70	6.	Horn (high) E61, E62
7.	Key slot M22	8.	Driver side door switch B16	9.	Inside key antenna (trunk room) B49

Fig 2: Security Control System Component Parts Location (2 Of 2)

Courtesy of NISSAN NORTH AMERICA, INC.

1.	Push-button ignition switch M50	2.	Stop lamp switch E110	3.	Clutch interlock switch E111 (M/T models)
4.	Trunk room lamp switch B306	5.	TCM F157 (A/T models)	6.	A/T shift selector (detention switch) M137 (A/T models)
7.	Inside key antenna (instrument center) M131	8.	Unified meter and A/C amp. M66, M67	9.	ECM M107
A.	View with instrument driver lower cover removed.	B.	View with instrument driver lower cover removed.	C.	View with center console assembly removed

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.