Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Infiniti QX80 AWDFACTORY OEM SERVICE PROCEDURE
Transfer Case DTCS
TRANSFER CASE DIAGNOSTIC TROUBLE CODE (DTC) INDEX
| DTC | Description |
|---|---|
| DTC P1802, P1803, P1804, P1809 | TRANSFER CONTROL UNIT |
| DTC P1807 | OUTPUT SHAFT SPEED SENSOR |
| DTC P1808 | WHEEL SPEED SENSOR |
| DTC P180C | SENSOR POWER SUPPLY (5V) |
| DTC P180D | TRANSFER ROTARY POSITION SENSOR |
| DTC P180E | SENSOR POWER SUPPLY (8V) |
| DTC P180F | TRANSFER INTERNAL SPEED SENSOR |
| DTC P1811 | POWER SUPPLY CIRCUIT FOR TRANSFER CONTROL UNIT |
| DTC P1813 | 4WD MODE SWITCH |
| DTC P1816 | PARKING/NEUTRAL POSITION SWITCH |
| DTC P1817 | TRANSFER MOTOR |
| DTC P181A | TRANSFER MOTOR TEMPERATURE SENSOR |
| DTC P181B | INCOMPLETE SELFSHUT |
| DTC P181C | TRANSFER MOTOR POWER SUPPLY |
| DTC P181E | STEERING ANGLE SENSOR |
| DTC P181F | INCOMPLETE CALIBRATION |
| DTC P1820 | ENGINE SPEED SIGNAL |
| DTC P1826 | TRANSFER FLUID TEMPERATURE |
| DTC P1829 | ACCELERATOR PEDAL POSITION SENSOR |
| DTC P182A | TRANSFER HI-LO POSITION SENSOR |
| DTC P182B | TRANSFER LOCK POSITION SENSOR |
| DTC P1830 | ABS OPERATION SIGNAL |
| DTC P1831 | VDC OPERATION SIGNAL |
| DTC P1832 | TCS OPERATION SIGNAL |
| DTC U1000 | CAN COMM CIRCUIT |
| DTC U1010 | CONTROL UNIT (CAN) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
