2013 Infiniti M56 xFACTORY OEM SERVICE PROCEDURE

Component Function Check

  1. PRECONDITIONING 

    Check that all of the following conditions are satisfied.

    TESTING CONDITION 

    • Vehicle driven distance: More than 5, 000 km (3, 107 miles)
    • Barometric pressure: 98.3 - 104.3 kPa (0.983 - 1.043 bar, 1.003 - 1.064 kg/cm2 , 14.25 - 15.12 psi)
    • Atmospheric temperature: 20 - 30°C (68 - 86°F)
    • Engine coolant temperature: 75 - 95°C (167 - 203°F)
    • Transmission: Warmed-up
      • After the engine is warmed up to normal operating temperature, drive vehicle until "ATF TEMP 2" (A/T fluid temperature sensor signal) indicates more than 60°C (140°F).
    • Electrical load: Not applied
      • Rear window defogger switch, air conditioner switch and lighting switch are OFF. Steering wheel is straight ahead.
    • Engine speed: Idle
    • Gear position: Neutral (or parking)

      : GO TO 2.

  2. PERFORM SPEC IN DATA MONITOR MODE 

    WITH CONSULT

    NOTE: Perform "SPEC" in "DATA MONITOR" mode in maximum scale display.
    1. Perform basic inspection. Refer to "WORK PROCEDURE ".
    2. Select "B/FUEL SCHDL", "A/F ALPHA-B1", "A/F ALPHA-B2", "MAS A/F SE-B1" and "MAS A/F SE-B2" in "SPEC" of "DATA MONITOR" mode with CONSULT.
    3. Check that monitor items are within the SP value.

      Is the measurement value within the SP value? 

      YES: INSPECTION END

      NO: Proceed to "DIAGNOSIS PROCEDURE ".

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.