2013 Infiniti M56 BaseFACTORY OEM SERVICE PROCEDURE

DTC Detection Logic

DTC No. Trouble diagnosis name (Trouble diagnosis content) DTC detecting condition Possible cause
P0451 EVAP SYS PRES SEN (EVAP control system pressure sensor performance) ECM detects a sloshing signal from the EVAP control system pressure sensor
  • Harness or connectors (EVAP control system pressure sensor circuit is shorted.)

    (Crankshaft position sensor circuit is open or shorted.)

    [Camshaft position sensor (bank 1) circuit is shorted.]

    (Accelerator pedal position sensor 2 circuit is shorted.)

    (Battery current sensor circuit is shorted.)

    (Refrigerant pressure sensor circuit is shorted.)

  • EVAP control system pressure sensor
  • Crankshaft position sensor
  • Camshaft position sensor (bank 1)
  • Accelerator pedal position sensor 2
  • Battery current sensor
  • Refrigerant pressure sensor
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.