Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
4WAS SYSTEM: Protection Function (4WAS Main Control Unit)
4WAS system enters in the protection function mode (4WAS system temporarily stopped) if 4WAS system continues the heavy load condition or the sensor self-check condition. (4WAS system reactivates automatically if the heavy load condition and the self-check condition are resolved.) 4WAS warning lamp stays OFF in the protection function mode.
| DTC | Error area and root cause | Contents of protection function |
|---|---|---|
| - | 4WAS main control unit power supply temporary malfunctioning condition | 4WAS system is temporarily stopped. |
| - | 4WAS system heavy load condition | |
| - | The sensor of 4WAS system is in self-check condition |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
