Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Infiniti M37 BaseFACTORY OEM SERVICE PROCEDURE
Active Test Mode: Description
- 4WAS front actuator assembly activation is checked according to the control signal from CONSULT.
- 4WAS front lock solenoid valve (lock structure) is activated forcibly (ON/OFF) using each control signal of "LOCK OPERATION". Perform this mode when performing 4WAS front actuator adjustment.CAUTION: Never steer the steering wheel during "RELEASE".
- The steering angle sensor neutral point judgment (OK/NG) is performed using each control signal of "SLOW MODE".
Select test item Control signal Remarks LOCK OPERATION RELEASE 4WAS front lock solenoid valve lock is released. LOCK 4WAS front lock solenoid valve lock is applied. SLOW MODE MODE START Steering angle sensor neutral point check starts. (Turn the steering wheel rightward and leftward slowly. Steer until the turning stops.) MODE END Steering angle sensor neutral point check ends.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
