Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fail Safe (Passenger Side)
When a system malfunction is detected, deactivates a part of the system or all functions depending on the malfunctioning part.
When the malfunction condition recovers to the normal condition, the system returns to the normal operation.
| Display contents of CONSULT | Fail-safe | ||
|---|---|---|---|
| B2452: SEAT BLT MTR AS CIRC | Fully deactivates the whole operation. | ||
| B2455: CONTROL UNIT DR | Stops the operation in the conditions as per the following.(1)
|
||
| B2456: SEAT BLT PWR AS | Fully deactivates the whole operation. | ||
| B2457: CONTROL UNIT AS | Fully deactivates the whole operation.(1) | ||
| B2458: LOCAL COMM | Fully deactivates the whole operation.(1) | ||
| B2461: VHCL SPEED SIGNAL | Stops the operation in the conditions as per the following.
|
||
| B2466: DR/AS CONTROL UNIT | Stops the operation in the conditions as per the following.(1)
|
||
| B2471: SYS HEAT PROTC AS |
|
||
| B2472: BRAKE STROKE SENSOR | Stops the operation in the conditions as per the following.
|
||
| U0126: STRG ANG SEN SIG | Stops the operation in the conditions as per the following.
|
||
| U0428: STRG ANGL CAL | Stops the operation in the conditions as per the following.
|
||
| U1000: CAN communication circuit | Stops the operation in the conditions as per the following.(1)
|
||
|
|||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
