2013 Infiniti M35hFACTORY OEM SERVICE PROCEDURE

Component Function Check

WARNING: This page is about a different car, the 2012 Infiniti M35h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECTION START

    Turn ignition switch to START.

    Are any cylinders ignited? 

    YES: GO TO 2.

    NO: Go to "DIAGNOSIS PROCEDURE ".

  2. CHECK FUEL INJECTOR FUNCTION

    ◦ With CONSULT 

    1. Perform "INSPECTION MODE 5". Refer to "DESCRIPTION ".
    2. Start engine.
    3. Perform "POWER BALANCE" in "ACTIVE TEST" mode of "ENGINE" with CONSULT.
    4. Make sure that each circuit produces a momentary engine speed drop.

    ⓧ Without CONSULT 

    1. Perform "INSPECTION MODE 5". Refer to "DESCRIPTION ".
    2. Start engine.
    3. Listen to each fuel injector operating sound.

      Clicking sound should be heard  .

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Go to "DIAGNOSIS PROCEDURE ".

      Fig 1: Checking Fuel Injector Operating Sound
      G08255747Courtesy of NISSAN NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.