2013 Infiniti M35hFACTORY OEM SERVICE PROCEDURE

Work Procedure

WARNING: This page is about a different car, the 2012 Infiniti M35h. However, it is still accessible from the selected car via links, so may be relevant.
  1. START

    ◦ WITH CONSULT

    1. Turn ignition switch ON.
    2. Select "CLSD THL POS LEARN" in "WORK SUPPORT" mode of "ENGINE".
    3. Follow the instructions on the CONSULT display.
    4. Turn ignition switch OFF and wait at least 10 seconds.

      Check that throttle valve moves during the above 10 seconds by confirming the operating sound.

    ◦ WITHOUT CONSULT

    1. Perform "INSPECTION MODE 5". Refer to "DESCRIPTION ".
    2. Start the engine.
      NOTE: Coolant temperature is less than 25°C (77°F) before engine starts.
    3. Warm up the engine.
      NOTE: Raise engine coolant temperature until it reaches 65°C (149°F) or more.
    4. Turn ignition switch OFF and wait at least 10 seconds.
      NOTE: Check that throttle valve moves during the above 10 seconds by confirming the operating sound.

      : END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.