2013 Infiniti M35hFACTORY OEM SERVICE PROCEDURE

HPCM: Work Procedure

WARNING: This page is about a different car, the 2012 Infiniti M35h. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM HPCM RECOMMUNICATING FUNCTION
    1. Install HPCM.
    2. Contact backside of registered Intelligent key* to push-button ignition switch while brake pedal is depressed, then turn ignition switch ON.

      *: To perform this step, use the key that is used before performing HPCM replacement.

    3. Maintain ignition switch in the ON position for at least 5 seconds.
    4. Turn ignition switch OFF.
    5. Check that the vehicle can be set to READY.

    : GO TO 2.

  2. PERFORM ADDITIONAL SERVICE WHEN REPLACING HPCM

    Perform the following procedure, HBC-98, "Work Procedure".

    : END

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.