2013 Infiniti M35hFACTORY OEM SERVICE PROCEDURE

System Initialization: Description

WARNING: This page is about a different car, the 2012 Infiniti M35h. However, it is still accessible from the selected car via links, so may be relevant.

Initialize the system if any of the following work has been done.

  • When control unit replaced.
  • Electric power supply to power window switch or motor is interrupted by blown fuse or disconnection and connection of the negative terminal of 12V battery, etc.
  • Removal and installation of regulator assembly.
  • Power supply to the power window main switch or power window motor is cut off by the removal of 12V battery terminal or if the battery fuse is blown.
  • Disconnection and connection of power window main switch harness connector.
  • Removal and installation of motor from regulator assembly.
  • Operation of regulator assembly as an independent unit.
  • Removal and installation of door glass.
  • Removal and installation of door glass run.

The following specified operations can not be performed under the non-initialized condition.

  • Auto-up operation
  • Anti-pinch function
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.