The vehicle can be set to READY by the following operations.

NOTE:

When an Intelligent Key is within the detection area of inside key antenna and when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
When setting the vehicle to READY, the BCM monitors the following conditions.
- Brake pedal operating condition
- Selector lever position
- Vehicle speed

VEHICLE SPEED: LESS THAN 4 KM/H (2.5 MPH)

	Vehicle condition		Push-button ignition switch operation frequency
	Selector lever	Brake pedal operation condition	Push-button ignition switch operation frequency
OFF → ACC	-	Not depressed	1
OFF → ACC → ON	-	Not depressed	2
OFF → ACC → ON → OFF	-	Not depressed	3
OFF → READY ACC → READY ON → READY	P or N position	Depressed	1
READY → OFF	-	-	1

VEHICLE SPEED: 4 KM/H (2.5 MPH) OR MORE

	Vehicle condition		Push-button ignition switch operation frequency
	Selector lever	Brake pedal operation condition	Push-button ignition switch operation frequency
READY → ACC	-	-	Emergency stop operation
ACC → READY (Return operation after emergency stop operation while driving)	N position	-	1
Emergency stop operation Press and hold the push-button ignition switch for 2 seconds or more. Press the push-button ignition switch 3 times or more within 1.5 seconds.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Ready Set Condition Table By Push-Button Ignition Switch Operation