2013 Infiniti JX35 FWDFACTORY OEM SERVICE PROCEDURE

Component Description

Component Function
Pre-crash seat belt control unit (driver side)
  • Integrated front seat belt pre-tensioner, control unit and seat belt motor.
  • Controls pre-crash seat belt control unit (passenger side) as slave control unit.
  • Seat belt motor operates when belt is extended and retracted.
Pre-crash seat belt control unit (passenger side)
  • Integrated front seat belt pre-tensioner, control unit and seat belt motor.
  • Is controlled by pre-crash seat belt control unit (driver side) as master control unit.
  • Seat belt motor operates when belt is extended and retracted.
Brake pedal stroke sensor
  • Varies voltage based on brake pedal position and sends the signal to pre-crash seat belt control unit (driver side).
  • There are 2 signals sent from the brake pedal stroke sensor (brake pedal stroke sensor signal 1 and 2).
  • Pre-crash seat belt control unit (driver side) judges the stroke distance and speed of the brake pedal based on the voltage signals sent by each side of the sensor.
Seat belt buckle switch (driver side) Fastening of seat belt is judged. This signal is used for control of driver pre-crash seat belt system.
Seat belt buckle switch (passenger side) Fastening of seat belt is judged. This signal is used for control of passenger pre-crash seat belt system.
BCM The following signals are received from the BCM via CAN communication:
  • ignition ON signal
  • sleep/wake signal
  • door switch signal
Air bag diagnosis sensor unit The following signals are received from the air bag diagnosis sensor unit via CAN communication:
  • pre-rollover signal
  • collision signal
ABS actuator and electric unit (control unit) ABS operation signal is received from ABS actuator and electric unit (control unit) via CAN communication.
ADAS control unit Intelligent brake assist operation signal is received from ADAS control unit via CAN communication.
Combination meter Vehicle speed signal is received from the combination meter via CAN communication.
Steering angle sensor The following signals are received from the steering angle sensor via CAN communication:
  • steering angle sensor signal
  • steering angle sensor speed signal
  • steering angle sensor neutral position adjustment completion signal
  • steering angle sensor malfunction signal
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.