Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Infiniti JX35 AWDFACTORY OEM SERVICE PROCEDURE
RELAY CONTROL SYSTEM: System Description
IPDM E/R activates the internal control circuit to perform the relay ON-OFF control according to the input signals from various sensors and the request signals received from control units via CAN communication.
CAUTION:
IPDM E/R integrated relays cannot be removed.
| Control relay | Input/output | Transmit unit | Control part | Reference page |
|---|---|---|---|---|
| Front fog lamp relay | Front fog lamp request signal | BCM (CAN) | Front fog lamp | FRONT FOG LAMP CIRCUIT |
|
|
BCM (CAN) |
|
HEADLAMP (LO) CIRCUIT HEADLAMP (HI) CIRCUIT |
| Tail lamp relay | Position light request signal | BCM (CAN) |
|
PARKING LAMP CIRCUIT |
|
Front wiper request signal | BCM (CAN) | Front wiper | FRONT WIPER DOES NOT OPERATE |
| Front wiper auto stop signal | Front wiper motor | |||
| Ignition relay-1 | Ignition switch ON signal | BCM (CAN) | Ignition relay-1 | B260A IGNITION RELAY |
| Vehicle speed signal | Combination meter (CAN) | |||
| Push-button ignition switch | Push-button ignition switch | |||
| Fuel pump relay | Fuel pump request signal | ECM | Fuel pump | FUEL PUMP |
| ECM relay | ECM relay control signal | ECM | ECM relay | POWER SUPPLY AND GROUND CIRCUIT |
| Throttle control motor relay | Throttle control motor relay signal | ECM | Throttle control motor relay | P2101 ELECTRIC THROTTLE CONTROL FUNCTION |
| A/C relay | A/C compressor request signal | ECM (CAN) | A/C compressor | MAGNET CLUTCH |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.