2013 Infiniti G37 BaseFACTORY OEM SERVICE PROCEDURE

CONSULT Function and System Application*1: Function

Mode Function
All DTC Reading Display all DTCs or diagnostic items that all ECUs are recording and judging.
Work Support This mode enables a technician to adjust some devices faster and more accurately.
Self Diagnostic Results Retrieve DTC from ECU and display diagnostic items.
Data Monitor Monitor the input/output signal of the control unit in real time.
CAN Diagnosis This mode displays a network diagnosis result about CAN by diagram.
CAN Diagnosis Support Monitor It monitors the status of CAN communication.
Active Test Send the drive signal from CONSULT to the actuator. The operation check can be performed.
ECU Identification Display the ECU identification number (part number etc.) of the selected system.
Configuration Function to READ/WRITE vehicle configuration.
SRT&P-DTC Confirmation The state of System Readiness Test (SRT) items, the presence or absence of permanent DTC(1), and driving conditions can be checked.
DTC work support DTC reproduction procedure can be performed speedily and precisely.
Others Other results or histories, etc. that are recorded in ECU are displayed.
(1) Permanent DTC is not applied for regions where it is not mandated.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.