Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Infiniti QX56 AWDFACTORY OEM SERVICE PROCEDURE
Input/Output Signal Chart
| Sensor (or signal) | ==> | TCM function | ==> | Actuator |
| Transmission range switch Accelerator pedal position signal Closed throttle position signal Wide open throttle position signal Engine speed signal A/T fluid temperature sensor Output speed sensor Vehicle speed signal Manual mode switch signal Stop lamp switch signal Input speed sensor 1, 2 Yaw rate/side/decel G sensor Tow mode switch signal |
Line pressure control (
LINE PRESSURE CONTROL ) Shift change control ( SHIFT CHANGE CONTROL ) Shift pattern control ( SHIFT PATTERN CONTROL ) Lock-up control ( LOCK-UP CONTROL ) Fail-safe control ( FAIL-SAFE ) Self-diagnosis ( DIAGNOSIS SYSTEM (TCM) ) CONSULT communication line ( DIAGNOSIS SYSTEM (TCM) ) CAN communication line ( U1000 CAN COMM CIRCUIT ) |
Input clutch solenoid valve Direct clutch solenoid valve Front brake solenoid valve High and low reverse clutch solenoid valve Low brake solenoid valve Torque converter clutch solenoid valve Line pressure solenoid valve Anti-interlock solenoid valve 2346 brake solenoid valve A/T CHECK indicator lamp Tow mode indicator lamp Shift position indicator Back-up lamp relay Starter relay |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
