Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Function Check
- CHECK ENGINE COOLANT TEMPERATURE (ECT) SENSOR
- Turn ignition switch OFF.
- Disconnect ECT sensor harness connector.
- Remove ECT sensor. Refer to "COMPONENT PARTS LOCATION ".
- Check resistance between ECT sensor terminals by heating with hot water as shown in the figure.
Terminals Condition Resistance (kΞ©) 1 and 2 Temperature [Β°C (Β°F)] 20 (68) 2.35 - 2.73 50 (122) 0.68 - 1.00 90 (194) 0.236 - 0.260 Is the inspection result normal?Β
YES: GO TO 2.
NO: Proceed to "DIAGNOSIS PROCEDUREΒ ".
- CHECK INTERMITTENT INCIDENT
Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".
Is the inspection result normal?Β
YES: INSPECTION END
NO: Proceed to "DIAGNOSIS PROCEDUREΒ ".
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.