Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection
- CHECK HIGH PRESSURE FUEL PUMP SOLENOID
- Turn ignition switch OFF.
- Disconnect high pressure fuel pump harness connector.
- Check the resistance between high pressure fuel pump connector terminals as per the following.
+ - Condition Resistance High pressure fuel pump Terminal 1 2 Temperature 20 - 30Β°C (68 - 86Β°F) 9 - 11 Ξ© Is the inspection result normal?Β
YES: INSPECTION END
NO: Replace high pressure fuel pump. Refer to "REMOVAL AND INSTALLATION ".
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.