2012 Infiniti M37 BaseFACTORY OEM SERVICE PROCEDURE

Active Test Mode: Description

  • 4WAS rear actuator assembly activation is checked according to the control signal from CONSULT.
  • The control signal forcibly activates (ON/OFF) 4WAS rear assembly, performs the self-diagnosis and checks each sensor in "SELF DIAGNOSTIC MODE".
    CAUTION: Perform the active test while the vehicle is stopped.
Select test item Control signal Remarks
SELF DIAGNOSTIC MODE ON
CAUTION: Perform the active test while the vehicle is stopped.
4WAS rear actuator assembly activates. It activates in the same direction as the steering angle by inputting the steering angle.
OFF 4WAS rear actuator assembly stops the activation.
ACTIVE TEST - STANDARD VALUE

Monitor item Active test "ON"
STEERING ANG 0Β° (Neutral) R 90Β° L 90Β°
RR ST ANG-MAI 2.4 V Approx. 4.4 V Approx. 0.4 V
RR ST ANG-SUB 2.4 V Approx. 4.4 V Approx. 0.4 V
MOTOR CURRENT No output (Approx. 0 A) Output (change)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.